Views:
On the Micro Series, press the STOP key on the keypad or open the Stop circuit between terminals 1 and 2 on the terminal strip. On the SM-Plus & SM Series, open the stop circuit between terminals 1 and 2. Faults can only be cleared if the condition that caused the fault has passed.

Note: Power sag & control faults cannot be cleared by simply pressing the "STOP" command. You must reset the drive using parameter named "PROGRAM". Once in this program, choose "RESET 60", or "RESET 50", if your base frequency is 50HZ. At this point, all settings will be reset to factory settings and you will lose your "USER" settings.